Problem with Divide Surface

Hey mates, I just have a problem with dividing a lofted surface in grasshopper ( everything has done within Grasshopper ), have a look at attached photo to make the problem explicit and more clear.. Can anyone help me please ?!

Cheers

Attachments:

prob.bmp, 1.1 MB

Replies to This Discussion

Permalink Reply by David Rutten on November 10, 2011 at 1:49am

What is the actual error message (hover over the red balloons to see the messages)?

What do you expect to achieve by dividing a surface with less than 1 sections per edge?

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by Hardi Barznji on November 10, 2011 at 4:13am

Thanks David for replying...

When I feed the Lofted Surface to the any sort of Division it says error with ( I or S ) !!

I want to divide the surface to a grid, for instance its very easy to do that when you have a simple surface

but the question is how can I divide this complex surface which is lofted through 5 Curves ?!!

Cheers

Permalink Reply by Danny Boyes on November 10, 2011 at 4:37am

From the image above it looks like a polysurface. These components only work on surfaces. Change your loft settings so that the resulting loft is a single surface.

Permalink Reply by Hardi Barznji on November 10, 2011 at 1:45pm

Thanks Danny,

I understand what's the problem "Poly-surface" !! hmmmm

So we can say this is a limitation of Grasshopper, as there is no any component to divide Poly-surfaces..

Cheers

RSS