algorithmic modeling for Rhino
Ok David,
I think I should start being a tester for you :D Just found another one that is really weird.
I am using Mesh Brep in a Cluster on some planar surfaces. As soon as I Save & Close the Cluster, the solution changes to something much worse. Deleting the Mesh Brep component and placing it again produces the original result.. until I save.
To reproduce this inside the cluster delete the Mesh Brep component and place a new one in its place. Save & Close the Cluster.
Please find a solution for this!!
Before saving:
After saving:
Thanks, Armin.
Tags:
Welcome to
Grasshopper
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson. Powered by