Grasshopper

algorithmic modeling for Rhino

Please help overcome the problem. (The discussion did not find the solution to the problem ?!)
Thank you all for your attention and help.

Views: 904

Reply to This

Replies to This Discussion

Is this a question?

Can you do ANYTHING in GH?  Like create the cone?  Maybe create the plane or surface cutting through it at a 45 degree angle?

This isn't complicated at all but if you can't at least create the cone in GH then you need to do more homework.

use UnrollSrf command in rhino after trimming a Cone, you can measure the distances, I guess... Not sure what the problem is though.

Delighted with your decision!
Thank you for your attention and support!

So this had nothing to do with Grasshopper?   ZZZ

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

© 2019   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service