Grasshopper

algorithmic modeling for Rhino

Control Servo with Firefly

hi guys,

i have just started with firefly and my arduino-board.
i have a problem with the servo. 
first of all my setup:

-Arduino Uno REV 3 
(Arduino 1.6.7)
-Tower Pro Micro Servo SG90

Rhino 5 SR12
Grasshopper 0.9.0075
Firefly 1.0.0.70


Uno Write Out: same number as the Number Slider to DPin5 - (i have tried all pwm pins on my arduino board)
Uno Write Msg: Now writing values to the arduino board.

When i`m moving the slider only the RX light on my arduino board is blinking and the servo does not move.


I am Sure the Servo is working i have tried it to with the Program in Arduino
Examples / Servo / Sweep
Its working.

I`m not sure what i`m doing wrong.

hope somebody can help me,
Thanks!

Views: 2289

Replies to This Discussion

Permalink Reply by Omer on January 20, 2016 at 6:53am

Hi,

Your Dpin 5 needs to be set so Servo Mode.

Right click on the Dpin5 and set it to Servo instead of Digital.

that should do it.

Permalink Reply by aJ on January 20, 2016 at 11:49pm

hi omer,

thank u for ur reply, but i had another big mistake in my setup.

i used an old firmata, this was my major problem.

Permalink Reply by Ahmed Elshafei on March 24, 2016 at 4:28pm

may be you need right click on Pin 05 and choose Servo not Digital and if it doesn't work please try to use external Power or Battery 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service