Grasshopper

algorithmic modeling for Rhino

Hi David, I was preparing animation with point cloud using Cloud Display to visualise points. During rendering, points are turning to white rectangles with different sizes. So half animation is ok and half is just with rectangles.



Views: 331

Replies to This Discussion

Hi Adam,

there have been a number of display problem with the sprite drawing of clouds. I'm not quite sure where to start debugging it. I also don't know if there's a difference between Rhino4 and Rhino5. If it's a Rhino4 problem only I'm tempted to ignore it, otherwise I'll have to get Steve to take a good long look at the sprite drawing code he wrote.

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Hey, I just run same script on Rhino5 and it works perfect so far. Ok, so if there are no plans to fix that on Rhino4 then time to switch to Rhino 5 :)

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service