algorithmic modeling for Rhino
Hi David,
I don't believe the solver is disabling. As I cannot simple disconnect wires and reconnect them elsewhere without huge lag also If I select some components they show up green in the Rhino Document
EDIT:
Only when I go and change a variable early on in the definition does it devoid itself of solving power
Tags:
Could the lag be caused by autosave? Disabling the solver won't in fact stop the last solution from being active. Computed data remains 'live' and if its geometry it will remain visible and go green when selected. It's only when you change some data that all downstream stuff should go orange.
--
David Rutten
david@mcneel.com
Poprad, Slovakia
Can there be an option to "flush" the system when I disable the solver? so that I can quickly change wires around and sliders, I don't need to know about the last solution because I already know it is way to stupid and processor hungry.
F5 used to do just that, but people felt F5 should recompute even if the solver was disabled. F4 could be Erase (solver disabled or not), would that work?
--
David Rutten
david@mcneel.com
Poprad, Slovakia
Would be good
Well, it's F6 as F4 is already used.
--
David Rutten
david@mcneel.com
Poprad, Slovakia
Welcome to
Grasshopper
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson. Powered by