Bug 0.9.0055: Solver Not Disabling Completely

Hi David,

I don't believe the solver is disabling. As I cannot simple disconnect wires and reconnect them elsewhere without huge lag also If I select some components they show up green in the Rhino Document

EDIT:

Only when I go and change a variable early on in the definition does it devoid itself of solving power

Replies to This Discussion

Permalink Reply by David Rutten on May 21, 2013 at 4:03am

Could the lag be caused by autosave? Disabling the solver won't in fact stop the last solution from being active. Computed data remains 'live' and if its geometry it will remain visible and go green when selected. It's only when you change some data that all downstream stuff should go orange.

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by Danny Boyes on May 21, 2013 at 4:16am

Can there be an option to "flush" the system when I disable the solver? so that I can quickly change wires around and sliders, I don't need to know about the last solution because I already know it is way to stupid and processor hungry.

Permalink Reply by David Rutten on May 21, 2013 at 4:22am

F5 used to do just that, but people felt F5 should recompute even if the solver was disabled. F4 could be Erase (solver disabled or not), would that work?

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by Danny Boyes on May 21, 2013 at 5:13am

Would be good

Permalink Reply by David Rutten on May 21, 2013 at 7:25am

Well, it's F6 as F4 is already used.

David Rutten

david@mcneel.com

Poprad, Slovakia

RSS