Chris Tietjen's Discussions (1,213)

View

Discussions Replied To (1206)	Replies	Latest Activity
"No, actually it most often fails because of closed rails so the work around is to op…" Chris Tietjen replied Dec 26, 2012 to About sweep 2	7	Dec 26, 2012 Reply by maxleach
"?" Chris Tietjen replied Dec 25, 2012 to LOFT & EXTRUSION	3	Dec 28, 2012 Reply by Chris Tietjen
"" Chris Tietjen replied Dec 25, 2012 to About sweep 2	7	Dec 26, 2012 Reply by maxleach
"This gives an approximation of bending in a simple beam. It could be modified to al…" Chris Tietjen replied Dec 24, 2012 to Model a beam using Grasshoopper+Kangaroo	5	Dec 28, 2012 Reply by Robert Vier
"Your section curve has to be at the start/end points of the rail curves." Chris Tietjen replied Dec 24, 2012 to About sweep 1/2	2	Dec 24, 2012 Reply by maxleach
"I posted the file again in case I forgot to internalize the curve data in the earlie…" Chris Tietjen replied Dec 24, 2012 to Emergent Problem with Millipede	16	Dec 27, 2012 Reply by Marios Tsiliakos
"Here I used two 'connected' lines to get the node for the point load. " Chris Tietjen replied Dec 24, 2012 to Emergent Problem with Millipede	16	Dec 27, 2012 Reply by Marios Tsiliakos
">What you meant is that I should use linear load instead of point load for that s…" Chris Tietjen replied Dec 24, 2012 to Emergent Problem with Millipede	16	Dec 27, 2012 Reply by Marios Tsiliakos
"My first look at this but for starters you can only apply a point load at a node of…" Chris Tietjen replied Dec 24, 2012 to Emergent Problem with Millipede	16	Dec 27, 2012 Reply by Marios Tsiliakos
"Without considering a specific design it would be hard to say exactly what might be…" Chris Tietjen replied Dec 23, 2012 to Typical grasshopper to fabrication workflow and hardware	3	Dec 23, 2012 Reply by Chris Tietjen