Grasshopper

algorithmic modeling for Rhino

Joseph Oster's Discussions (2,584)

Search Forum

View

Discussions Replied To (2570) Replies Latest Activity

"Mirror, mirror: 3D surfaces from this doesn't seem too difficult."

Joseph Oster replied Jan 10, 2016 to Ornamental Structures - Iterative Subdivision

 15 Jan 11, 2016
Reply by Joseph Oster

"Well, I looked but I still don't understand Hoopsnake.  Your result looks recursive…"

Joseph Oster replied Jan 10, 2016 to Ornamental Structures - Iterative Subdivision

 15 Jan 11, 2016
Reply by Joseph Oster

"Impressive!  I'll re-install HoopSnake and check it out. Here is Anemone, but I woul…"

Joseph Oster replied Jan 10, 2016 to Ornamental Structures - Iterative Subdivision

 15 Jan 11, 2016
Reply by Joseph Oster

"Use Anemone, not Hoopsnake! But this looks more like recursion than just iteration?"

Joseph Oster replied Jan 10, 2016 to Ornamental Structures - Iterative Subdivision

 15 Jan 11, 2016
Reply by Joseph Oster

"The 'Base Crv' resulted in a "Periodic Planar Curve" in my last post so I was forced…"

Joseph Oster replied Jan 10, 2016 to Use points as Z vectors

 7 Jan 16, 2016
Reply by Cheezy-neezy

"In fact...  Instead of dividing these curves by an arbitrary number of points (28),…"

Joseph Oster replied Jan 10, 2016 to Use points as Z vectors

 7 Jan 16, 2016
Reply by Cheezy-neezy

"There is another issue here between the two curves, besides their disparate start po…"

Joseph Oster replied Jan 10, 2016 to Use points as Z vectors

 7 Jan 16, 2016
Reply by Cheezy-neezy

"No, it's not clear at all.  As I said before, there is no obvious correlation betwee…"

Joseph Oster replied Jan 10, 2016 to Use points as Z vectors

 7 Jan 16, 2016
Reply by Cheezy-neezy

"As to "flowy" surface edges, it's likely due to 'Display | Preview Mesh Settings' -…"

Joseph Oster replied Jan 10, 2016 to Use points as Z vectors

 7 Jan 16, 2016
Reply by Cheezy-neezy

"This forum is probably your best bet, esp. regarding Grasshopper.  However, I'm not…"

Joseph Oster replied Jan 10, 2016 to Learning parametric design

 3 Jan 10, 2016
Reply by Joseph Oster

RSS

About


McNeel Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2026   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service