Grasshopper

algorithmic modeling for Rhino

Joseph Oster's Discussions (2,584)

Search Forum

View

Discussions Replied To (2570) Replies Latest Activity

"Clearly, many things are possible and there are many different ways.  If you want to…"

Joseph Oster replied Jul 8, 2016 to Isolating unobstructed objects from a point

 38 Jul 8, 2016
Reply by ng5 Alex

"One more refinement...  I added a "Resolution" slider that is used to compute an eve…"

Joseph Oster replied Jul 7, 2016 to Isolating unobstructed objects from a point

 38 Jul 8, 2016
Reply by ng5 Alex

"OK, as often happens, take a little break and what seemed difficult is suddenly easy…"

Joseph Oster replied Jul 7, 2016 to Isolating unobstructed objects from a point

 38 Jul 8, 2016
Reply by ng5 Alex

"Here you go; a "flashlight" surface with adjustable beam (horizontal, vertical and p…"

Joseph Oster replied Jul 7, 2016 to Isolating unobstructed objects from a point

 38 Jul 8, 2016
Reply by ng5 Alex

"Here is a slightly different method for getting the surface points more evenly distr…"

Joseph Oster replied Jul 7, 2016 to Isolating unobstructed objects from a point

 38 Jul 8, 2016
Reply by ng5 Alex

"I didn't remember much about how this works but within a few minutes, I was able to…"

Joseph Oster replied Jul 7, 2016 to Isolating unobstructed objects from a point

 38 Jul 8, 2016
Reply by ng5 Alex

"Here is an amusing addition to the previous post; it colors each point based on the…"

Joseph Oster replied Jul 7, 2016 to how many lines start or end at one point

 5 Jul 8, 2016
Reply by Aristo Compasso

"How do you define "neighboring points"? How do you eliminate duplicate lines?  (i.e.…"

Joseph Oster replied Jul 7, 2016 to how many lines start or end at one point

 5 Jul 8, 2016
Reply by Aristo Compasso

"Oh, and more specific to your question, you use the data to construct points (obviou…"

Joseph Oster replied Jul 3, 2016 to How to add a manual data list to Populate Geometry

 3 Jul 3, 2016
Reply by Joseph Oster

"P.S.  To get column 1 (actually column 0) as a list, do the following - the 'i' inpu…"

Joseph Oster replied Jul 3, 2016 to How to add a manual data list to Populate Geometry

 3 Jul 3, 2016
Reply by Joseph Oster

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service