Grasshopper

algorithmic modeling for Rhino

David Rutten's Discussions (13,838)

Search Forum

View

Discussions Replied To (13597) Replies Latest Activity

"I think the partnership between NING and MODE was severed recently, and NING's been…"

David Rutten replied Oct 4, 2016 to Grasshopper Site Problems???

 4 Oct 4, 2016
Reply by Ethan Gross

"It's a programming error, meaning whoever wrote the code inside that component is tr…"

David Rutten replied Oct 4, 2016 to Imp@IT with QGIS, File Path Issue and Runtime Error

 1 Oct 4, 2016
Reply by David Rutten

"It's certainly true some people learn better by instruction than by action, but I'm…"

David Rutten replied Oct 3, 2016 to I am new to grasshopper, i have seen the 13 videos on this site and a few couple videos on youtube. What is the best way to proceed ahead in learning grasshopper?..

 9 Oct 4, 2016
Reply by Armin Seltz

"In addition to that advice, I'd say you should pick a project you understand very we…"

David Rutten replied Oct 3, 2016 to I am new to grasshopper, i have seen the 13 videos on this site and a few couple videos on youtube. What is the best way to proceed ahead in learning grasshopper?..

 9 Oct 4, 2016
Reply by Armin Seltz

"Hi Nadine, it's a bit hard to figure out exactly that the target image is supposed…"

David Rutten replied Oct 1, 2016 to Help Needed - Got Stuck!

 1 Oct 1, 2016
Reply by David Rutten

"You can't, but I can feature topics for a while if I feel it would benefit the major…"

David Rutten replied Oct 1, 2016 to Feature my grasshopper workshop

 1 Oct 1, 2016
Reply by David Rutten

"Merging mass properties is a difficult process. Rhino has ways to compute the centre…"

David Rutten replied Sep 30, 2016 to Center of Mass definition

 6 Oct 3, 2016
Reply by Andrew Chan

"Because JoinCurves returns an array of curves. It is entirely likely that not all th…"

David Rutten replied Sep 29, 2016 to Curve[] and joining curve

 5 Sep 30, 2016
Reply by Mario L

"The reason (which is not a very good one) is that rhino does not guarantee that line…"

David Rutten replied Sep 29, 2016 to GH no longer referencing geometry

 4 Sep 30, 2016
Reply by Karl Singline

"I'm surprised there's no component which outputs the curve degree, but you can calcu…"

David Rutten replied Sep 28, 2016 to if statement for curve degree

 2 Sep 29, 2016
Reply by deli dumrul

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service