Grasshopper

algorithmic modeling for Rhino

David Rutten's Discussions (13,838)

Search Forum

View

Discussions Replied To (13597) Replies Latest Activity

"But which different corners? You'll have to be specific about this before you'll be…"

David Rutten replied Dec 19, 2016 to fillet

 5 Dec 19, 2016
Reply by David Rutten

"You're right, somehow the Voronoi3D component outputs invalid breps. The problem see…"

David Rutten replied Dec 19, 2016 to Voronoi 3d wrong behaviour

 2 Dec 19, 2016
Reply by Marcelo Arguello

"Do you care which corner? If not, then since a square is very likely to start and en…"

David Rutten replied Dec 19, 2016 to fillet

 5 Dec 19, 2016
Reply by David Rutten

"You need to use the Fillet component which requires a curve parameter, in addition t…"

David Rutten replied Dec 19, 2016 to fillet

 5 Dec 19, 2016
Reply by David Rutten

"It's a recursive process, so already it will be difficult to do in GH. Can you also…"

David Rutten replied Dec 19, 2016 to help! surface curvature subdivision

 6 Dec 20, 2016
Reply by DoradoZYL

"Whether it's hard depends on how you define your arcs. It's pretty trivial to replac…"

David Rutten replied Dec 19, 2016 to Spirals in grasshopper

 5 Dec 19, 2016
Reply by Jesus O. Villarreal G.

"Yup, three steps: Multiply your value by 0.001 (ie. one over thousand) Round this v…"

David Rutten replied Dec 19, 2016 to Round(x[,d]) -- How Do I use this ?

 12 Dec 19, 2016
Reply by Dave Wilson

"I'm lost, what's a 'semi closed curve'? As long as the two end-points of a curve are…"

David Rutten replied Dec 19, 2016 to How to flip the Direction of a curve based on the Z value of the start and end point

 8 May 12, 2017
Reply by Hendrik

"Makes sense to me, unless you already know how to type in working VB or C#, scriptin…"

David Rutten replied Dec 19, 2016 to How to flip the Direction of a curve based on the Z value of the start and end point

 8 May 12, 2017
Reply by Hendrik

"There is no single component that does what you describe (it's far too specific), bu…"

David Rutten replied Dec 19, 2016 to volumes along curve

 2 Dec 19, 2016
Reply by DANIEL GUETA

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service