Discussion (26,994)

Sort by:

Discussions	Replies	Latest Activity
how to merge a list of lists to a list Hello everyone, I am quite new to grasshopper but i am learning steadily. however i have encountered a problem that i wanted an urgent an… Started by Thomas Tiel Groenestege	7	Feb 28, 2013 Reply by David Stasiuk
crossref problem On the attached image, I have a point on top of every roof surface. I wanted to draw a line from each tower (grey red objects) to every po… Started by Tash Tash	2	Feb 28, 2013 Reply by Tash Tash
Isocurves when baking.... Hi, I'm sure this has been requested before, but it would be nice if when using right click> Bake, that GH could obey the show/don't sho… Started by Mitch Heynick	0	Feb 28, 2013
Importing the GH mesh for structural analysis To what structural analysis and design softwares like STAAD Pro, SAP2000, ANSYS, ABAQUS, OASYS etc. has the mesh generated by GH been impor… Started by Chintan Pathak	8	Feb 28, 2013 Reply by Jon Mirtschin
Custom parameter becomes zero when is clustered. Hello. I created a custom parameter that integrates IGH_Goo derived objects (not geometric). These parameters contain high level objects in… Started by Francisco Garcia Collado	0	Feb 28, 2013
Trouble selecting a certain group of points Hey GH community I looking for some help to something that should be quit simple. I'm having a bit of a brain fart and wanted to reach out… Started by Jason Wheeler	5	Feb 28, 2013 Reply by Dedackelzucht
new grid Hi, i have a question: I want to design a grid with curves (created by me) and replace it to recgrid. how can I do it??thanks Started by Antonio Giordano	12	Feb 27, 2013 Reply by Alex Leiva
CURVE PERPENDICULAR OFFSET Hi all, Iam facing some problem when trying to offset all of these curves to its perpendicular direction. Curves to the left of the screen… Started by Mu_	4	Feb 27, 2013 Reply by Mu_
Sendai Mediatheque Columns Hi, I think there is a very simple solution for this, however I am not terribly adept at grasshopper. I have this definition of how to cre… Started by Andy	4	Feb 27, 2013 Reply by JORGE A SILEN RIVERA
trouble with surface trim Having trouble with surface trim. I'd like the trimmed material and the untrimmed material to be easily isolated (into two indexes perhaps)… Started by hlm	1	Feb 27, 2013 Reply by hlm