Discussion (26,994)

Sort by:

Discussions	Replies	Latest Activity
a circular arc knowing the center of the circle and two other points on the arc. I have two points A and B, that I would like to connect with a circular arc with the help of grasshopper ... the center of the circle is al… Started by Ahmed Hossam	6	Apr 23, 2013 Reply by Ahmed Hossam
reorder points according to their distance - problem!!! I am trying to create a curve out of points. The points are not in the order i want them to be. I am trying to set the order so as my curve… Started by Georgios Kontominas	8	Apr 23, 2013 Reply by Georgios Kontominas
Offset Surface / Offset Mesh - Creates Self-Intersection Hello All, I am trying to offset a wavy surface by 3mm. (The surface is originally sweep2 but also works when I loft between the two ra… Started by ptr	0	Apr 23, 2013
Parametric division of a curve (brick wall) Dear all, this is the first time that I open a discussion and I hope you can help me. My problem is a little bit hard to explain but I will… Started by Andrea Albanese	10	Apr 23, 2013 Reply by Michael Pryor
(Another!) Serial read problem in Firefly Hi guys, I'm communicating with a 3D printer via Grasshopper / Firefly (and eventually) Silkworm. So far, I can quite happily send G-Code… Started by fergal.coulter	1	Apr 23, 2013 Reply by fergal.coulter
Simply question on Offset Hi guys. I have a problem. I would like to offset my windows ... some go outside, some inside. I would like that all of my windows go outsi… Started by Landscape	5	Apr 23, 2013 Reply by Landscape
multiple lines from points on two curves hello all. i have the following setup: a rhino-curve, offset by a grasshopper component, both subdivided with a divide component. now i wan… Started by roberto gagliano	11	Apr 23, 2013 Reply by Danny Boyes
line perpendicular to a curve Hello everybody, Im just starting with grasshopper and I wanted to know if somebody can tell me how to do the following: I have a curve and… Started by Alex Fernandez	12	Apr 23, 2013 Reply by Despina A
How to Trim Mesh Surface Hi guys, I've been working on this surface from a voronoi study to a delaunay triangulation and this is the following result: Said so… Started by lv2311	3	Apr 22, 2013 Reply by lv2311
kangaroo, spring not pulling naked edges Hi All, I created a mesh surface and would like to use the naked edges as lines that are pulled by the spring force, which are also contro… Started by Rob C	0	Apr 22, 2013