Grasshopper

algorithmic modeling for Rhino

Notches on a surface

HI, I apologize if this question has been asked already,

HI, I was wanted to create notches between the intersection of two surfaces, so when fabricated they fit together without the aid of glue, also the surfaces follow a curve thus making some of the intersections at awkward locations. However, I have had trouble creating these notches, any advice?

Thanks.

Views: 753

Attachments:

Replies to This Discussion

Permalink Reply by Sue Wang on April 25, 2013 at 9:15pm

Thanks for your help I'll check it out later

Permalink Reply by Stephanie Choy on April 24, 2013 at 7:09am

herro sue

Permalink Reply by Sue Wang on April 25, 2013 at 9:15pm

Herro

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service