Grasshopper

algorithmic modeling for Rhino

Falsecolor does not work in Ladybug and Honeybee

Hi,

I am trying to set up an example model and I notice that falsecolor rendering does not work even though the 3d rendeing is there but the false color lines do not show up. I was able to do the glare analysis. The only problem I have is to run falsecolor. I have attached the .gh model. 

Views: 689

Attachments:

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on April 27, 2017 at 7:26pm

Do you have falsecolor2.exe in radiance\bin?

Permalink Reply by saram on April 28, 2017 at 10:40am

Yes, I do have Falsecolor2 and evalglare in c\radiance\bin

Permalink Reply by Mostapha Sadeghipour Roudsari on April 29, 2017 at 7:12am

It works fine. You were connecting the image from the run daylight component to the image viewer instead of FalseColor. Also you should not adjust the exposure for a false color image. If you need to do so, do it before generating the false color.

Permalink Reply by saram on May 1, 2017 at 2:45pm

Thanks for noticing my mistake. It works now.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service