Grasshopper

algorithmic modeling for Rhino

HI Grasshoppers,

I am facing a problem lofting a series of brep edges.

The loft failed.

Would be really great if someone could let me know how to fix that.

Thank you for your patience with me and your support.

I have attached the definition.

F

Views: 810

Attachments:

Replies to This Discussion

Hi the seams of your curves were misaligned in pairs, so the the seam of curve 0 was on the side opposite that of curve 1 and so on, all the way up. I got the loft to work using 'normal' but apparently, you want the resulting surface to be developable and when I try that, its a mess - even in Rhino. Do you know for a fact that its possible?

Attachments:

Hi. Findie

Try to fix your series of rotation angles from radian to degree.

Every 3 radian means more than 171 degree which means almost half turn of each section curves so that every section seams located alternately.

OMG.

that was the mistake Hyungsoo Kim!!!!!

hope others will learn from it as well.

Great to have such a support.

Thank you once again.

Thanks goes as well to you, Ethan!!!!

Good observation Hyungsoo. I just treated the symptom and not the disease.

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service