algorithmic modeling for Rhino
Hi,
I just started using HB and LB this week and made some tutorials on Youtube. Everything works great until I close grasshopper and want to reopen the same file again.
I get some warnings on the canvas, but they usually disappear if I let fly LB and HB and then disconnect+connect some wires.
Once there are no more warnings on the canvas I still dont get any results for the simulation, although the simulation runs without any errors.
I searched on the internet for any solution but I wasnt able to find one so far.
Maybe it is just a simple Beginner-Mistake, but I would be very greatful if anyone could help me.
Thank you!
Tags:
Replies are closed for this discussion.
It might be that the Ladybug and Honeybee components are executing after the other components on the canvas - you can try selecting those two and choosing "enable" and then afterwards doing the same with the rest of the definition. Or maybe even just hitting F5 to re-run the definition would be sufficient.
Welcome to
Grasshopper
Added by morteza khorsand 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson. Powered by