Grasshopper

algorithmic modeling for Rhino

I'm trying to run some Energyplus simulations, I get two error messages:

1. No .eio file was found adjacent to the .csv _resultFileAddress.Results cannot be read back into grasshopper without this file.

2-2. No surface information was found in the imported .eio file adjacent to the .csv _resultFileAddress.Data cannot be normalized by surface area and the data tree outputs for surface data will not be grafted by zone.

Views: 1758

Replies are closed for this discussion.

Replies to This Discussion

It's usually a result of failure of energy simulation in the first point. Are you sure the simulation is running fine?

Hi Mostapha,

I get the same error..I've seen all the discussion replies; I updated the file components as Rania did too; I wrote a new the algorithm so to avoid Rania problems(as suggested from Chris) but still I have the same error: "1. No surface information was found in the imported .eio file adjacent to the .csv _resultFileAddress.Data cannot be normalized by surface area and the data tree outputs for surface data will not be grafted by zone". It's a long time that I'm trying to figure out what's the problem..could you please have a look to the file?THANK YOU SO MUCH

Attachments:

Ernesto,

There were supposed to be problems with the file you attached?

Just a couple of issues that i fixed it works fine for me. See attached.

-A.

Attachments:

Abraham,

thank you very much, now it works!

Ern

Mustapha, thanks for replying to my question. The simulation fails, I'm not sure why, as you can see from he picture I think I have the right setup.

After I updated my HB using the update Honeybee components the simulation fails, it used to run fine right before the update. I noticed some empty outputs coming out the HB flying component, is there something wrong with my installation? I really need to figure out what's happening with this as I have a deadline to finish this work for a research paper I'm working on. 

Thanks in advance 

That shouldn't make any issues. Can you upload your file so we can take a look? I can check it later today. -Mostapha

Here are the files, I really appreciate it.

Attachments:

and here is the GH file

Attachments:

Also it might be helpful if you read readMe! output of runEnergySimulation component. You can find the error in your simulation there.

I'll take a look right now

Here is the error output, it says there is a missing input. However, the picture below shows that I've connected all required data, unless I'm missing something

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service