Grasshopper

algorithmic modeling for Rhino

Hi David, 

Everytime I have any parameter with a big amount of geometry internalised , it freezes and takes a long time to recover when one component is plugged to any other component. However, it works properly when changing any value without having to connnect wires
If I copypaste the definition on another empty GH canvas, without saving it as a new file, it works as smooth as it should. When I save it with a name, it gets slower again. Can this be solved?

Thanks in advance!

Views: 960

Attachments:

Replies to This Discussion

 the problem is the autosave. Autosave happens every time you disconnect/reconnect wires or change any value - unless the file is unsaved, in which case autosave does not occur. Since you have a lot of internalized data, this has to be re-written many times over - you're writing a 4.2 MB file multiple times a second. You can get around this by disabling autosave (which you do at your own risk) or not relying on internalizing so much data (your breps look like they were converted from meshes - why not just use meshes which are much lighter?).

Hi Andrew, thanks for the reply, I din´t know it was the autosave what slow down the execution. Well the file was created in order to show the problem, I made that breps out of meshes just to show that issue

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service