Grasshopper

algorithmic modeling for Rhino

hello! i have a mesh i produced through kangaroo and a surface below, which is let's say in my project the previous level. What i need now is to fillet the mesh with the surface. I dont know if there is such a possibility in grasshopper. i would prefer it of course in order to change the mesh and simultaneously the fillet will change. THANKSSS

Views: 1344

Attachments:

Replies to This Discussion

I see 3 possibilities:

  1. Manually construct the fillet with extrusions or similar
  2. Convert the mesh into a surface and use a standard fillet
  3. Convert the surface into a mesh, and use some mesh smoothing to round the connection

For (2), see here for an example of getting relaxed NURBS from a Kangaroo mesh

For (3) I'm imagining constructing an initial flat mesh joining the 2 parts, then keeping the vertices of the top and bottom fixed, while using springs and Laplacian smoothing to round out the connecting part so tangency is preserved.

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service