Grasshopper

algorithmic modeling for Rhino

Louvres

Hi,

 

Im trying to create louves from a lofted surface. Using the scale non-uniform component I was scaling the subsurfaces (shown in the pic) down in the y direction only, but now the surface in a bit more curved, the scale starts to deform the curves, slowly becoming straighter. Any ideas on how i could do it?

 

Many Thanks!!

Views: 1284

Attachments:

Replies to This Discussion

Permalink Reply by djordje on October 30, 2012 at 6:15am

Hi Natalie,

Do you want to create a single louvre from particular subsufrace, or to convert all subsurfaces to louvres?
I was not sure which one of these two you want to make, so there are both methods in the files attached. Here is the preview of the second one:

Attachments:
Permalink Reply by Natalie Chelliah on October 30, 2012 at 7:53am

Thanks for your reply, i worked it out in the end, i used the contour tool.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service