Grasshopper

algorithmic modeling for Rhino

3D voronoi attractor

Hello guys,

I've decided to make a 3d voronoi within a box. Being a grasshopper newbie, I get an error with the srfsplit. Could you guys help me figuring out what may be wrong ?

Also, I have a question. I would like to attach a point attractor, making the openings inside smaller, the further from point. While searching this forum, i've found a definition for a 2d voronoi scale, point attractor. Is it ok to use that in here ?

Thanks in advance for showing the proper directions,

Aleksander

Views: 23489

Attachments:

Replies to This Discussion

Permalink Reply by x-stratos on December 22, 2013 at 12:44pm

thank you Joaquim!

I used the values that you sent me on the image,and everything is working fine!

thanks again!

Permalink Reply by ShiSer on June 6, 2017 at 11:20am

Hello, i have a question please! what you set on the [GEO]? 

Permalink Reply by Rulon Bukv on July 7, 2017 at 5:30pm

It is the ground (or just your attractor) surface

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service