Grasshopper

algorithmic modeling for Rhino

loadcase

hello every body i want to input combination of loads to karamba.for wind load i have defined one point load and for dead and live load another point load i have defined.i want to combine them together and input it to karamba.but i donot know how to use l case.and which number i should input it.i have read manual but it did not help me.what can i do

Views: 573

Replies to This Discussion

Permalink Reply by Karamba3D on July 19, 2016 at 6:27am

All load-components have an input-plug called 'LCase'. Here you can specify the number of the load-case where the load should be active. Load-cases are numbered starting from zero. A negative number means that the corresponding load is active in all load-cases.

There are two options for combining loads: Either give them the same load-case number or specify load-factors via the 'LCFactor' input-plug of the ModelView and select '---All---' in the drop-down-list under 'Load-case Selection'.

Best,

Clemens

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service