Grasshopper

algorithmic modeling for Rhino

Hi,

I just started using HB and LB this week and made some tutorials on Youtube. Everything works great until I close grasshopper and want to reopen the same file again.

I get some warnings on the canvas, but they usually disappear if I let fly LB and HB and then disconnect+connect some wires. 

Once there are no more warnings on the canvas I still dont get any results for the simulation, although the simulation runs without any errors. 

I searched on the internet for any solution but I wasnt able to find one so far. 

Maybe it is just a simple Beginner-Mistake, but I would be very greatful if anyone could help me. 

Thank you!

Views: 223

Replies are closed for this discussion.

Replies to This Discussion

It might be that the Ladybug and Honeybee components are executing after the other components on the canvas - you can try selecting those two and choosing "enable" and then afterwards doing the same with the rest of the definition. Or maybe even just hitting F5 to re-run the definition would be sufficient. 

Thanks for your reply. I have noticed that it all works as it should, but I only can see the chart by klicking on the Ladybug_3D Chart when it turns green. If it isn´t marked I can´t see the results? very strange:) 

...I attached an image to demonstrate it. 

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service