Grasshopper

algorithmic modeling for Rhino

Views: 305

Albums: VORONODE SHELF
Location: Stockholm

Comment

You need to be a member of Grasshopper to add comments!

Comment by hamia Aghaiemeybodi on November 21, 2014 at 8:40am

Ok. I made a quick example which shows how to get intersection and offset them, basically showing the logic and I think you can take it from there, I hope it helps:

 Find the GH file here:

https://www.dropbox.com/s/yij3ka1fjreu1d4/QuickexampleForShelf.gh?dl=0

Comment by Weihao Liang on November 20, 2014 at 5:04pm

I don't know whether I want to do is the same as yours. The first picture is the reference I found, and the second picture is the shelf I am working on. I would like to use the joint in the reference. I will try whether I can figure it out according to your method. Thank you for your time ~

Comment by hamia Aghaiemeybodi on November 20, 2014 at 12:27pm

Hi weihao, I made that shelf 2 years ago and lost my files on my previous computer. but it's quite simple. if you send me your definition I'll try to do the same on yours! Just briefly explaining you need to go through these steps:

-Find each corner

-locate one, two or as many joint you need on each edge

-Place a plane on those points

-Get the intersection with surfaces

-Orient it on xy plane

-depending on how long you need your joints to be cut the intersection result

-offset on both sides

-fillet the angle

-connect offset lines and Join them

you are almost there!

If you want to change anything manually you can take it from there!

I hope it helps.

 

Comment by Weihao Liang on November 19, 2014 at 8:05pm

Hi~Would you mind sharing the definition about how to make the joint in grasshopper? I am working on my studio and want to make a joint which is similar to yours. But I have some problems with figuring out the definition~ Thanks

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service