Grasshopper

algorithmic modeling for Rhino

Kangaroo/Weaverbird

Hi everyone.

I'm trying to use Weaverbird Mesh Edges command to extract edges from a planar mesh I created to apply wind force in Kangaroo. I keep on receiving the same error message: 'Two consecutive edges have the same value... Try to use Weaverbird's Clean Up Mesh first'.

The mesh is quite an irrugular shape. How can I 'clean it up'? I tryied to rebuilt it in Rhino but it still not working.... Thanks.

Views: 5084

Replies to This Discussion

Permalink Reply by Giulio Piacentino on March 2, 2012 at 2:34am

Hi Fabio, this means that the mesh has some collapsed edges. Imagine turning on grip points and pulling points one on top of the other. You can use Rhino 5 "Repair mesh wizard", Rhino 4 _Weld command with then _RebuildMesh, or try using the "Mesh Weldvertices" component with some tolerance in [uto]'s MeshEdit from within Grasshopper.

Permalink Reply by Fabio on March 3, 2012 at 8:05am

Grazie Giulio. It's now working.

Permalink Reply by Diego Xavier on September 21, 2012 at 7:52pm

Tnks!

Permalink Reply by Julian Cuadros on October 28, 2013 at 8:21pm

Thanks !!

Permalink Reply by jozze on August 20, 2014 at 9:14am

grazie!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service