Grasshopper

algorithmic modeling for Rhino

Direct import from rhino

When we need to directly use geometry from rhino for eg. a  rectangle using context pop up menu ,in newer versions of gh it starts the rhino command for rectangle , implying to draw it again...Is there a way to select the geometry that is already been drawn.so that intuitive changes can be done to it later on..Kindly help.

 

Views: 1107

Replies to This Discussion

Permalink Reply by Luis Fraguada on May 3, 2014 at 3:05pm

Try the generic curve param instead of the rectangle param.

Permalink Reply by x3curve on May 5, 2014 at 2:18am

Yes, that works .thanks a lot.

Permalink Reply by Dimitar Baldzhiev on May 3, 2014 at 3:13pm

Maybe you can just use generic Geometry component.. connect it to rectangle if you so insist.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service