algorithmic modeling for Rhino
extension, filter, condition
Hello,
Till know I am still having a problem with the if statement in grasshopper...
I am working on a definition where I want to try doing the following:
By extending a curve, if the extension from L0 side is bigger then the L1 side -->
do the following ---> draw a cruve from the end extension curve perpendicular to the initial curve--> project this new curve into the surface created by the closest initial end point of the inial curve before extension..., and if not do same steps in the other side
Sounds hard?
Views: 335
- Attachments:
-
-
IF statement.jpg, 339 KB
-
Replies to This Discussion
-
Permalink Reply by Vicente Soler on
-
Is this what you want? I'm making many assumptions that seem to be in your drawing.
Curve is a straight line, connecting bottom corners of the surfaces, the surfaces are perpendicular to the line, amongst others.
It's not very useful to post a screenshot of a GH definition that's so zoomed out that you can't tell the components apart.
- Attachments:
-
-
extend.gh, 13 KB
-
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Field Trap
Added by Parametric House 0 Comments 0 Likes
-
Subd Bridge
Added by Parametric House 0 Comments 0 Likes
-
Twisted Groove
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by
