problem with sweep2rail command and remote panel

Comment

Comment by idtasos on May 13, 2010 at 9:11am

amazing!!! thank you very much for your time!!

Comment by Danny Boyes on May 13, 2010 at 9:03am

To show you just how sensitive this is watch this video, using your model.Sweep2_EndPoints.avi

Comment by idtasos on May 13, 2010 at 8:43am

1.3dm1.ghx

Comment by Danny Boyes on May 13, 2010 at 5:51am

can you post the model?

Comment by idtasos on May 13, 2010 at 5:21am

the thing is the end point of the section curve coincide with the ones from the 2 rails, see pic below

Comment by Danny Boyes on May 13, 2010 at 5:17am

With the Remote panel it is a known bug and is undergoing a rewrite along with clusters and therefore have not been functional in GH for a while.

Comment by Danny Boyes on May 13, 2010 at 5:10am

Make sure that the end points of the section curve coincide with the end points of the rail curve. Example below shows two identical setups apart from the end point of the section crv of the left example has been moved away from the end point of the rail curve.

Also have a look at this http://www.grasshopper3d.com/forum/topics/how-to-create-sweep2-with... for other areas where the sweep components are limited. As the Sweep components don't feature in v 0.7 I think David is aware of their limitations and will be addressing them in due course.