Mapping a same drawing on variables surfaces

Comment

Comment by djordje on October 26, 2012 at 5:46pm

David, both curves and reference, target surfaces need to planar?

Comment by Skyhopper on October 25, 2012 at 4:55pm

Great!! thanks a lot David ! It's very important to link information in this way, thanks :)

Comment by David Lister on October 24, 2012 at 9:46pm

This is what the Map Srf component is really good for. You need to set a 'Source' surface under your 2d curve and then can map to multiple 'target' surfaces. You can use multiple initial curves as well, just make sure you graft the multiple target surfaces so you get them on all targets.