generative modeling for Rhino
how to make a digital model of a twisted cylinder
I'm currenty doing a study project where I bend/twist a cylinder. see images below
Anyone who have an idea how to construct this geometry.
Its simply a cylinder where you grab two opposite sides and rotate one of the sides to the desired angle.
In the images this is approximately 270 degrees
Anyone who have an idea how to construct this geometry.
Its simply a cylinder where you grab two opposite sides and rotate one of the sides to the desired angle.
In the images this is approximately 270 degrees
Views: 94
Comment
-
Comment by Jesper Thøger Christensen on December 12, 2010 at 3:57am -
Hey Chris
I posted the question here as well
http://www.grasshopper3d.com/forum/topics/paper-strip-model-with?gr...
But if you have a solution your very welcome :-)
-
Comment by Christoph von Mach on December 11, 2010 at 10:02am -
hey jesper,
it seems like you didn't attach any images. send them over and i can have a look at it. greetings to switzerland.
best
chris
Translate
Search Grasshopper
Photos
© 2012 Created by Scott Davidson.
Powered by
You need to be a member of Grasshopper to add comments!
Join Grasshopper