overcraft's Page

overcraft replied to overcraft's discussion Surface split

"Noone know how is it possible bypass this problem?"

Jun 23, 2012

overcraft posted a discussion

Surface split

Hi at all, i divided a surface with a brep section and then the sames curve sholud be used to form the smaller surfaces to paneling the main surface. Well until here there's no problem but when i connect this curves to a surface split the results are a lot of surfaces, trimmed and untrimmed, that are not the results i hoped. While if i bake the curves from the brep and the i select these from rhino the split surface work wonderfully.Do you know how to oblige gh to work fine?…See More

Jun 22, 2012

1 Comment

overcraft replied to overcraft's discussion Division surface through curves

"an another time...thanks michael, i saw that command in the afternoon, but i wasn't convinced becouse it seemed that wasn't working....but it didn't true....it worked on! see you soon, thanks <?xml version="1.0"…"

Jun 18, 2012

Michael Pryor replied to overcraft's discussion Division surface through curves

"split surface component "

Jun 18, 2012

overcraft posted a discussion

Division surface through curves

Hi at all. I have a little problem with a division of surface, i tried with the isotrim but the results are not satisfactory becouse i would divide the surface through a series af curves that i extracted with the brep section. Someone could help me please????…See More

Jun 18, 2012

2 Comments

Michael Pryor replied to overcraft's discussion Choose between two curves

"yea, here you don't need dispatch."

May 31, 2012

overcraft replied to overcraft's discussion Choose between two curves

"well...without dispatch is better.... i'm still an amateur"

May 31, 2012

overcraft replied to overcraft's discussion Choose between two curves

"thanks really really a lot to both!!"

May 31, 2012

overcraft replied to overcraft's discussion Choose between two curves

"it's working!!!!!! ahahhahahahhahahhaahha thanks for the patience!!! "

May 31, 2012

Sameer Kumar replied to overcraft's discussion Choose between two curves

"I agree, Michael. I had forgotten about the stream gate... Much more elegant."

May 31, 2012

overcraft replied to overcraft's discussion Choose between two curves

"well to solving the problem i will use only one curve that will be modified in the second including new control point so the dispatch will working and then i will shatter the second curve (that above in the first image) becosue i need this…"

May 31, 2012

Michael Pryor replied to overcraft's discussion Choose between two curves

"if the items are from separate places, as you show above, then I suggest "strem gate (filter)" if the items are in one list I suggest list item. "

May 31, 2012

Sameer Kumar replied to overcraft's discussion Choose between two curves

"From the screenshot, I am not sure what the Dispatch component does for you. If all you are trying to do is creating a switch for which curve goes through, then either one of the List Item or Dispatch would do it and you wont need both."

May 31, 2012

overcraft replied to overcraft's discussion Choose between two curves

"it was for this if the list item and dispatch don't working, becouse there are two source object, and only one at time shold be extrused"

May 31, 2012

Michael Pryor replied to overcraft's discussion Choose between two curves

"yes, but in his case, the list item makes no sense, because the two curves are already separate, so just use the one you want. based on the screenshot he would be grouping the 2 curves to immediately separate them again."

May 31, 2012

Sameer Kumar replied to overcraft's discussion Choose between two curves

"I think you need to flatten your 'L' input in the List Item component... In the image above, both the curves have an index number '0'. Once you flatten them and bring them to the same tree level, they will be 0 and 1, and your…"

May 31, 2012