generative modeling for Rhino
Yuta Ito's Discussions
how to loft and sweep two lines
2 Replies
Dear all I'm just a beginer and I don't know much about Grasshopper. And now I'm in trouble with Loft or sweep in grasshopper. I woul like to make new surfaces between two shell shaped sufaces. In…Continue
Started this discussion. Last reply by Yuta Ito Jul 16, 2010.
Yuta Ito's Page
Latest Activity
Ángel Linares commented on Yuta Ito's photo
Master Thesis Project
"Nice research! keep posting results! Which technics are you using to push the metal sheet? I supose that you cut it with sand/plasma/etc, and then use some kind of milled form to push the metal sheet to the correct deformation state."
Profile Information
- Company, School, or Organization
- The University of Tokyo, Architecture Department
Yuta Ito's Photos
Comment Wall
- No comments yet!
Translate
Search Grasshopper
© 2012 Created by Scott Davidson.
Powered by
