Aste Ploug Henriksen's Page

"Yea, clouds cause light to be scattered in all directions and hardly no light is absorbed in clouds. When the light is scattered in all directions the orientation of the building is irrelevant, for daylight factor calculations. You can read more…"

"Understood. Wonderful solution.Thank you for the reply once again Arste,Could I ask you more about the "cloudy weather" influence on calculation?It's characteristic (cloudy weather) is that because due to clouds no direct sun…"

"I just used 1°Kelvin difference between indoor and outdoor temperature, to get (W/ΔK/M2). You can use 10°K difference but then you'll get Watts/Squaremeter Housing for Δ10°K. This will ofcourse return a energyloss…"

"did the same work for anyone else?"

"I did not understand you that part about the 1 degree deference and it' connection with heat loss units."

"Yea expect i used 1 degree difference to get heat loss in watts/per kelvin degree difference/square meter housing (W/ΔK/M2) which i then used later in my project. But you can use 10 degrees if you want, the optimal solution will be the same,…"

"So by "Evaluate" component you mean that the following formula has been inserted into "Evaluate" component: H = A * U * (ti - to) Where "A" is the area of the particular building element (wall, window, floor,…"

"Hi Djordje, yea it's true you can not export the heat loss from ecotect. I linked the total area for each building element (windows, floor, external walls etc.) and the related u-value for each element to an "Evaluate" component and…"

"Hi Aste, I am using the latest Geco, and there is no component responsible for "Heat loss".So how did you export the Heat loss from Ecotect to Grasshopper? Tak."

"Hi Suna you can follow this guide: http://usa.autodesk.com/adsk/servlet/ps/dl/item?siteID=123112&id=14838484&linkID=13734494"

"Is anyone else having trouble installing Karamba? The tab doesn't show in Grasshopper after I've installed the trial. Here's my set up  karamba_64bit_1_0_2_TRIAL_GH_09_0014 grasshopper_wip_20121030 - 0.9.0014  (for Rhino 5.0…"

"Hi Thomas, I get the same error message as Vangel, I use: GecoForGH_Installer_v1.033 GH0.9.xxxx grasshopper_wip_20121030 - 0.9.0014  (for Rhino 5.0 only) rh50EvaluationTimed_x64_en-us_20120927_2230 (the newest 90-day evaluation) Thanks"