surface bridging wb

Comment

Comment by Per Petersson on October 23, 2012 at 11:39am

Hi Paco

Sent you a message!

I was in the north of sweden. No computers no cellphone only reindeers on the road!!

Best regards

Per

Comment by Paco Ortiz Vázquez on October 18, 2012 at 12:36pm

sorry man!!! i've been busy, but give me your e-mail and i will send you my definition.

Comment by Per Petersson on October 11, 2012 at 10:24am

ahhh, thanks for that...

But tried it and that did not do the trick, is there something about how I select the surfaces? I use "Set Multiple Surfaces" (reference mode). Because I can switch to either have the upper or the lower surface doing the lofting by selecting the one after the other. But I cant get them to  both loft at the same time though.

So any other ideas? And thanks for keeping up with me, I am a newbie at GH... maybe its obvious.

Best regards

Per

Comment by Paco Ortiz Vázquez on October 10, 2012 at 9:25pm

check the second weave component, the one before the highlighted loft. That one is the problem, you have to switch to GRAFT the "2" in the component.

Comment by Per Petersson on October 10, 2012 at 2:02am

Hi again Paco

I think I got it together, but having problem with the lofts coming from the upper surface and I cant figure out how to make them or find them. Any hints would be very welcome!

Attached is my (our) def and the result I am having at the moment.

Comment by Paco Ortiz Vázquez on October 7, 2012 at 9:40pm

You're welcome!!!!! Please just share your results!!!! I'm here for any question that you could have forward!

Comment by Per Petersson on October 7, 2012 at 1:06pm

Hey Paco

And thanks a lot, really appreciate it.

I really like to figure out how to think with GH since I am not from the technical side of modelling, but from the art side.

So I will look into your def and see if I can learn something!

Many thanks

Per

Comment by Paco Ortiz Vázquez on October 7, 2012 at 12:14pm

Comment by Paco Ortiz Vázquez on October 7, 2012 at 12:13pm

hello there Per, sorry if I answer a little bit late but I've just read your comment. I share you the definition right here and I really hope that it works for you!. Cheers!

Comment by Per Petersson on October 1, 2012 at 12:52pm

Hi Paco

I really liked this! Would you care to describe how you done it?

Is it possible to move the "stems" start, with points or curves?

regards

Per