generative modeling for Rhino
section table
Comment
-
Comment by Alex Bahrami on December 21, 2010 at 2:53pm -
Thx and have a good time.
Regards
Alex
-
Comment by giac0mo on December 21, 2010 at 5:12am -
just dividing a plane in points, pushing some points to get the feet and then make curve pass trough new set of point...then offset and plane surface to extrude...
-
Comment by Alex Bahrami on December 6, 2010 at 7:14am
-
It's very nice! Can you give me a hint how you get it?
© 2013 Created by Scott Davidson.
Powered by
You need to be a member of Grasshopper to add comments!
Join Grasshopper