Raptor Pavillion

Comment

Comment by John Fredrickson on February 20, 2010 at 1:18pm

reminds me of the AA DRL10 pavillion

Comment by Erick Prins on February 8, 2010 at 3:49pm

The project consisted of a design challenge to create a bench with an incorporated solar shading system. Using this the initial massing studies were manually generated within rhino. The final design was picked and then a fabrication technique through grasshopper was scripted to define the ribs. The angle of each rib is defined through a centroid point of the object through which parallel planes are created to define the horizontal rib through the massing. once all component geometry was figured out we added the ribbing connection logic so that a physical model could be laser cut and fabricated.

Comment by adam.s on February 8, 2010 at 12:35am

Hey can you tell us the logic of making this?