Grasshopper

algorithmic modeling for Rhino

A simple planarized hexagon definition using Kangaroo 2.01 (and Lunchbox for the initial curves). All panels are absolutely flat.

Views: 1806

Comment

You need to be a member of Grasshopper to add comments!

Comment by marcello on November 27, 2016 at 8:57pm

Daniel, is there any way to keep the hexagons more similar looking * all the same like the parameter slider in the lunchbox component? and how/where would you adjust that in kangaroo 2

thanks for all your work !

Comment by SERGEY KUZNETSOV on June 13, 2015 at 6:46am
Thank you very much, Daniel !!!
Comment by Daniel Piker on June 13, 2015 at 4:59am

@Sergey - this error is usually caused by an outdated .net framework. Try installing 4.5.1 (not the 4.6 preview) from here: https://msdn.microsoft.com/en-us/vstudio/aa496123

(assuming you are using Windows 8.1)

Comment by SERGEY KUZNETSOV on June 13, 2015 at 4:35am

its perfectly work with 32bit sistem, but doesnt work with win64...

How to fix it?

Thanks!

Comment by SERGEY KUZNETSOV on June 13, 2015 at 3:13am

Hello!

I tried PlanarHex example, but Solver component is red - message - "Int32 System.Environment.get_CurrentManagedThreadId()". What did I do wrong?

Thanks 

Comment by Esteban Pacheco on April 15, 2015 at 5:51am

Hello Daniel: this is amazing, but im curious, it is possible to achieve similar results using kangaroo "1"?

many thanks,

Comment by Daniel Piker on April 10, 2015 at 4:19am

Hi Kim,

The ratio of U/V divisions need to be chosen so that the initial edge lengths are close to equal.

When planarizing, particularly with hexagons, we need to ensure that the polygons do not become self intersecting. Here this is achieved by constraining the maximum and minimum edge lengths to some ratio of the overall average edge length. For this to work though, it helps if the initial state has them within or close to this range.

If you turn on the visibility of the rest of the definition it probably helps to see how it is working.

Comment by Maurizio Barberio on April 9, 2015 at 2:24am

Hi Daniel,

I've the same problem of Kim hauer... maybe we need to change something in your definition to run. Thanks in advance!

Comment by Kim hauer on April 8, 2015 at 11:25am

Hi Daniel:

FYI, when I change the U or V in the panel connected to the Hex cell comp it breaks the script

Comment by Gavin on April 8, 2015 at 9:45am

Hi Daniel and dvdrbls: my bad. I forgot to Unblock. K2.01  is working great.

Regards,

Gavin

About

Translate

Search

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service