minimal-surface

Comment

Comment by June Chen on June 26, 2012 at 4:09pm

Thank you for your sharing, may I ask you about how to set up the 6 curves in the first? what are they different? thak you for your helping!!!★

Comment by Manuel Huerta on May 6, 2012 at 11:41am

gh definition:  http://dl.dropbox.com/u/13460554/Min-Surf-box.gh

Comment by Patana Rattananavathong on November 29, 2011 at 6:25pm

Thank you :D

Comment by Manuel Huerta on November 27, 2011 at 10:54pm

Ok, for this you'll need the Minimal Surface component, but you can also do this without it.

Basically what you do is repeat a shape in between two surfaces, it could be a "brep" or what ever shape you create, in this case the shape was created with "MinSurf" component from various "interpolate" curves, once you have the shape you want, create a "bounding box" around it (with bounding box component), after that create two surfaces in Rhino, then with "blend box" you will create sort of a big box contained by these surfaces, you can divide this "big box" by any number you want in X and Y direction, and finally repeat the base shape inside the blend box with "Box Morph", the number of times repeated is the number of divisions made in the blend box. Hope this is clear  =)

Comment by Manuel Huerta on November 25, 2011 at 10:44pm

sorry guys!, I've been very busy these days, I will post a small explanation this weekend

 

Comment by daniel DIAZ on November 24, 2011 at 1:28pm

i would appreciate an explanation as well!

Comment by Patana Rattananavathong on November 6, 2011 at 7:04pm

can you please explain to me how to create something like this?