Grasshopper

algorithmic modeling for Rhino

Views: 175

Comment

You need to be a member of Grasshopper to add comments!

Comment by Christian ivan ruiz mendoza on August 5, 2014 at 11:36pm

hi ..

how you managed to make coins in the correct angle according to your model?
some script did you use? or what was your method for achieving this geometry?

Comment by Toussaint Jimenez Rojas on September 1, 2012 at 7:09am

all MDF the sheets are always 15mm and the coins in some cases are 15mm and 25mm ( when the angle are obtuse to void the Disc Crashed with the broke forces 

Comment by djordje on September 1, 2012 at 6:56am

Thank you Toussaint!
So the coins are carved, and sheets are not carved?

And what material did you use for both coins and sheets?

Comment by Toussaint Jimenez Rojas on September 1, 2012 at 6:54am

Yes Djordje the coins are the conector between sheets and its carved and conect the sheets together

Comment by djordje on August 31, 2012 at 6:22pm

Very, very interesting.
These coins "dive" into the sheets and that is how they connect sheets together?

The coins are carved, and the sheets are not carved?

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service