Grasshopper

algorithmic modeling for Rhino

gFAB_v3: polysurface with custom spacing

Views: 431

Comment

You need to be a member of Grasshopper to add comments!

Comment by taz on October 12, 2009 at 5:10pm
Yerko,

All dimensions (parameters) are actual... Good point though.

Actual notch widths can be adjusted for tolerances, but the section curves would (technically) be smaller than actual (if you were trying to be extremely precise).

If this is an issue, you can offset the section curves...
Comment by stephane_tapsoba on October 12, 2009 at 10:33am
great work!!!
Comment by Yerko Lucic on October 12, 2009 at 10:29am
this is awesome.........
but i have one question...did you consider the loss of material due to laser cutting (for instance) as a tolerance in the "input parameters" area?....a 3mm acrylic begins to fit well on a 2.6mm notch....with a 3mm notch the structure gets all wiggly

About

Translate

Search

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service