Brick Experiments - AHO Fall 2010

Comment

Comment by Joakim Hoen on March 13, 2011 at 2:34pm

Thanks! Planar formwork made of particle board (see the pictures at the link).

Comment by stephanie chaltiel on March 10, 2011 at 8:16am

That's remarquable ! Did you use formworks ? If yes which kind ?

Thanks and Congrats !

Comment by Nicholas Pajerski on March 2, 2011 at 5:57pm

very well done!

Comment by Eric Werner on March 1, 2011 at 3:35am

Very nice!

 

Comment by Joakim Hoen on February 28, 2011 at 4:46pm

We used the 'hanging chains' from kangaroo as center-brick and modeled the underside of the bricks. From this we made planar formwork (see the particle board in the other pictures) for both sides of each brick guiding its position and tilt. Notice the kink in the formwork of the first two (out of three) layers of 'chains'. This was needed because slight inwards tilt of the structure caused by the curved base line.

 

Also, all the chains of each layer is the same length. This means the height of the structure at the top catenary is determined by the position of the anchor points on the base curve.

Comment by Endrjux on February 28, 2011 at 11:12am

fantastic!!!!!

Comment by Onur Ozkaya on February 28, 2011 at 4:30am

cool..

Comment by Arthur Mani on February 28, 2011 at 3:27am

This is fantastic ! How did you translate the 3d model into a full scale structure?