Grasshopper

algorithmic modeling for Rhino

A happy accident while implementing the ball pivoting algorithm. By ignoring any vertices that have already been used during each pivot, you can generate some fancy branching patterns.

Views: 491

Comment

You need to be a member of Grasshopper to add comments!

Comment by David Reeves on November 10, 2013 at 6:58am

It's one big mesh actually. I'm extracting certain faces of the triangulation produced by the ball pivoting algorithm and then handing them over to Weaverbird for some subdivision and smoothing.

Comment by Jesus Galvez on November 9, 2013 at 4:24pm

Nice! Are those surfaces or lines? Did you try your wooly paths on it?

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service