Grasshopper

algorithmic modeling for Rhino

Tolerances issue, fitting a panel

Hello,

Is there any way I could get the corner-points of the paneling to strictly (or at least be close to) coincide with the points? Preferably without having to make the panels smaller as I would like to have the option of a big or small grid. Please see the attached files. I greatly appreciate any help I could get.

Kindly,

Terese

Views: 405

Attachments:

Replies to This Discussion

Permalink Reply by Rajaa Issa on August 16, 2016 at 3:33pm

Hi Terese,

Do you need to have flat panels? If not and can use a little twisted ones, then you can use ptFaces (Generate Faces) component. See image:

Permalink Reply by Terese Wahlström on August 17, 2016 at 2:41pm

Twisted panels work just fine. Must have confused the both.. the panels are ofc not flat if they follow all four corners.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service