Grasshopper

algorithmic modeling for Rhino

Deform diamond panles

Hi, I want to make a surface with diamond panels and each panel retains its original size and will not deform when adapted to a curved surface, I tried with PanelingTools, someone will have some idea of ​​how to accomplish this ?? ..
Thank you

Views: 318

Replies to This Discussion

Permalink Reply by Rajaa Issa on October 20, 2014 at 1:13pm

Hi Carlos,

Deformation will depend entirely on your surface. If it is planar, or singly curved (from extrusion for example), then you can achieve that, but if the surfaces doubly curved, then it might not be possible.

Permalink Reply by Carlos Rivera on October 20, 2014 at 1:55pm

Hi Rajaa Issa, thanks for replying.

I am beginner and I lost a lot of time trying to find a solution in paneling tools, I think I'll have to try other methods.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service