Solve Adjacencies error

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on February 29, 2016 at 6:25am

Haven't checked your model but from your comments.

1. The floor surfaces should show as ground floor in case the z value of all the points is 0.

2. Are you having other zones on top of these zones? A roof changes to ceiling if the boundary condition is another surface and not outdoors 

Permalink Reply by Stefania Dinea on February 29, 2016 at 6:34am

Not at the moment - in a later stage I will have others on top. The thing is I create the zones from breps and I think I need to explode them and define each surface - which I was really looking forward to avoid. 

As i said I am working on the ground floor before i go up. 

On this subject - is there a tutorial or a file on how to make an atrium?

Permalink Reply by Mostapha Sadeghipour Roudsari on February 29, 2016 at 7:01am

The thing is I create the zones from breps and I think I need to explode them and define each surface - which I was really looking forward to avoid. 

Just make sure the Breps are modeled correctly. Check all of them to be at the same level and the surfaces are touching.

On this subject - is there a tutorial or a file on how to make an atrium?

I can't remember of any but it is quite similar to creating zones next to each other except that you will have more interior windows.

Permalink Reply by Stefania Dinea on February 29, 2016 at 7:08am

Cool - Thank you so much for your support.