Grasshopper

algorithmic modeling for Rhino

Ladybug Mesh Edges Triangulating

Is there anything I can do to clean up the way LB creates meshes? Even on rectangular surfaces, I always seem to get triangulated edges. Does this skew results at all, or is area of mesh face not connected to daylighting, radiation, and draft calculations? I've attached a screenshot example.

JM

Views: 193

Attachments:

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on May 10, 2017 at 8:12pm

Hi Jim,

You can create any mesh that you need and feed it into Ladybug for the analysis. In that case Ladybug will use the input mesh as it is.

Mostapha

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service