[solved] font issue

I'm following the 3rd tutorial by Chris Mackey. However, the font for display surface attributes looks strange (see below). Can anybody advise how to solve this problem? Thanks!

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Anton Szilasi on May 21, 2015 at 11:36pm

Hi Grashope

Ive never seen that happen before, would you like to send me your Grasshopper file an I'll take a look - ajszilasi@gmail.com

Cheers,

Anton

Permalink Reply by Grasshope on May 22, 2015 at 7:58am

thanks, Anton!

The file is downloaded from the dropbox link posted on Chris' tutorial on youtube, and I didn't change nothing:

https://www.youtube.com/watch?v=jMmBso9bL14&list=PLruLh1AdY-SgW...

Permalink Reply by Chris Mackey on May 26, 2015 at 3:40pm

Grasshope,

Thanks for posting this as a discussion. I wrote you a response in the LB+HB page comments but here it is again for the sake of other users who find this discussion:

The text looks like that because your Rhino model tolerance is not fine enough to capture all of the detail of the text. Type "Units" into the Rhino command bar and drop your tolerance down to a smaller value. Then re-compute or re-open the GH file.

-Chris

Permalink Reply by Grasshope on May 29, 2015 at 3:16am

Thank you very much, Chris! You suggestion solves the problem.

Permalink Reply by Guillermo Gutiérrez on December 7, 2016 at 6:01am