generative modeling for Rhino
My simulation is quite simple : just a bunch of straight lines connected to each other and used as springs.
When I generate those lines within Grasshopper, the simulation seems to run on twice the springs that were input, resulting in something quite different as expected.
But if I input these lines from existing Rhino lines, then the simulation runs fine with just the set of springs that were input.
Am I missing something, or is this a known limitation of Kangaroo ?
It appears that the duplication of springs is due to the fact I have two anchor points.
In fact, with only one anchor points, the simulation uses only the springs that I input but if I add a second anchor point, then Kangaroo duplicates the springs...
Try to flatten the anchor points input. Should do the trick..